On occasion, the oil burner may fail to pump oil. When this occurs, check the oil supply line to the furnace for leaks. If there…
Category: Oil Burner
A vacuum gauge and a pressure gauge are both used to service a fuel unit. With these two gauges, the individual can check the following:…
The capacity of an oil burner fuel pump should be sufficient to handle the total vacuum in the system. The vacuum is expressed in inches…
A two-stage pump has two sets of pumping gears. These pumps are used in installations with underground tanks where the combination of lift, horizontal run,…
A single-stage pump contains only one set of pumping gears (see Figure 1-23). These pumps are commonly used in single-pipe gravityfeed installations or two-pipe installations…
Some oil burners are available with combination oil and gas firing accessories that make it possible to use either of these fuels in the same…
Figures 1-19 and 1-20 show a typical vaporizing (pot-type) oil burner. The fuel oil is vaporized for combustion by heating it from below. The vaporized…
Rotary burners operate with low-pressure gravity and are available in a number of designs depending on the different conditions of use. In each case, the…
High-static oil burners are improved versions of flame-retention burners. They have an increased efficiency of 20 percent over flame-retention burners, and the high-static pressure developed…
Most oil furnaces and boilers prior to 1980 were installed with cast-iron head burners that had an efficiency rating of only about 60 percent. The…